Kia 2630035502 Engine Oil Filter Assembly

You can Select Your Vehicle to check if 2630035502 fits your vehicle.

It is important to change the oil frequently because as it ages, it becomes diluted and dirty leading to premature engine wear. Before you start however, make sure you have all the tools required for that job; drain pan, gloves made of rubber breaker bar, socket and filter wrench including rags or newspapers in case of spillage. After lifting and securing the front of the car using jack stands, remove the under cover on the engine if any. Find out where your drain plug as well as filters are in advance. The one who is driving should park on a level surface so that he can start up his vehicle and let the engine warm up some minutes before he switches off and opens up fill cap. Lift vehicle safely while placing drain pan under drain plug then pull out plug very carefully. Once metal shavings or chips are noticed after draining oil inspecting it throw away old oil and wipe clean plug threads before reinstalling drain plug making sure not to over tighten it with a wrench. Place a container beneath an oil filter catch which will hold old one when replacing with new lubricating gasket new lube attaching tightening per instructions attached motor's like this compare slide off replace with following directions on how much force is needed turn on ignition switch to test if everything works correctly again take away tools now bring back down so that fresh may be added via filler hole see level at once by inserting dipstick into opening turn engine once more checking again possible spot leaks fill crankcase put level meter Dispose properly of used oils by recycling them instead of pouring them into ground water or sinks.

Before starting, ensure you have all necessary tools, including rags or newspapers for spills.

Dispose of the old oil properly, either through recycling facilities or designated disposal sites. Never pour it on the ground or down a drain.

The necessary tools for an oil change include a drain pan, rubber gloves, breaker bar, socket, and filter wrench. Adequate rags or newspapers should also be on hand for spill cleanup.

Park the vehicle on level ground, start the engine, and let it reach its normal operating temperature before turning it off and removing the filler cap.