Kia 0K20133065A Seal-Oil

You can Select Your Vehicle to check if 0K20133065A fits your vehicle.

Wheel leaks often result from worn wheel seals. To replace, lift the vehicle on jackstands and remove the driveaxle(s). Carefully pry the wheel seal from the transaxle bore with a screwdriver or special tool. Install the new seal with a driver or deep socket, ensuring it's fully seated and lubricated. Reinstall the driveaxles.

Raise the rear of the vehicle and securely support it on jackstands. Block the front wheels to prevent the vehicle from rolling. Place the transmission in Neutral with the parking brake off. Carefully pry out the side gear shaft oil seal with a seal removal tool or a large screwdriver, making sure you don't scratch the seal bore. Using a seal installer or a large deep socket as a drill, install the new wheel seal. Drive it into the bore squarely and ensure it is completely seated. Lubricate the lip of the new seal with multi-purpose grease, then install the driveaxles. Check the differential lubricant level and add some if necessary to bring it to the appropriate level.

If a leak is suspected, raise the vehicle and support it securely on jackstands to inspect for lubricant on the side of the transaxle below the seal.

If the seal is leaking, lubricant will be found on the sides of the transaxle below the seals.

Installation is the reverse of removal, and the four retaining nuts should be tightened to the specified torque.